Installing ceramics properly and correctly using your cement requires planning and good attention so that the results are long-lasting and aesthetic. The following are the installation stages ceramics with the correct mu cement:

Also Read: Casting stage good formwork

• Surface Preparation:
  - Make sure the surface where the ceramic will be installed is clean from dust, dirt and oil. Clean with a brush or broom.
  - If there are cracks or damage to the surface, repair them first with material appropriate and allow to dry completely.


• Determination of Ceramic Patterns and Stacks:
  - Determine the ceramic placement pattern according to the desired design.
  - Make a guide line using a spirit level board or stringer to be sure ceramics are placed neatly.
  


• Cement Mix:
  - Mix your cement with water according to the instructions on the cement packaging. Make sure it's mixed has a good consistency, similar to pancake batter or toothpaste.


• Ceramic Removal:
  - Use a special hammer or other suitable tool to remove the ceramic from the pile with Be careful. Make sure not to damage the ceramic.


• Cement Application:
  - Use a trowel or dental spatula to apply the cement to the surface evenly. - Make sure there is a layer of cement that is thick enough but not excessive. Can use serrated trowel to create grooves in cement to increase adhesion.


• Ceramic Installation:
  - Install the ceramics one by one by pressing them gently onto the cement surface.
  - Press and shake the ceramic so that it sticks perfectly. Make sure the ceramic is aligned guide lines that have been created. - Use spacers between the tiles to maintain a consistent distance between them.


• Checks and Corrections:
  - Periodically check the level, lines and pattern of the ceramic tiles that have been installed. Correct if something doesn't fit. - Clean the cement that appears between the ceramic gaps while it is still wet.


• Finishing and Drying:
  - Once all the tiles are in place, let the cement dry for at least 24 hours or according to the instructions on the cement packaging. - After drying, clean any remaining cement that may still be on the ceramic surface with a damp cloth.


• Grouting:
  - Mix the grout according to the instructions on the package.
  - Apply grout to the gaps between the tiles with a grouting spatula. - Clean excess grout from the ceramic surface with a damp sponge after the grout has hardened.


• Connection Closure:
  - Connect and seal ceramic joints with waterproof silicone in areas such as room corners baths or surfaces that require protection from moisture.



By following the steps above carefully, you can install ceramics with Your cement is strong and durable. Be sure to follow the manufacturer's instructions for the product Your cement is used.

Twitter Facebook Google+ Pinterest LinkedIn

Share This Artikel